Broadata-communications 1700 Series Manuel d'utilisateur télécharger pdf (Page 7)

BCI 1700 User’s Manual

Fiber Optic Digital Video/Audio Transport System

Broadata Technical Support, (800) 214-0222

2.1 Mounting

Before installing the units into your housing, make sure there is

enough space to pull and connect both the electrical and optical

cables without stressing them beyond the manufacturer’s

limitations (also known as the bend radius minimum). Rack

Mount kits are available through special order.

2.2 Cabling and Connectors

In order to set up the BCI 1700 properly, make sure to observe

the following instructions when installing the proper cables. The

1700 requires two parts to the cabling setup: the electrical and

the optical. For the optical part, observe the following

procedures, as there are various types of optical connectors as

illustrated on the following page.

2.2.1 Electrical Cable Connection

The only available cable connections on the electrical side are

for video sources.

Proceed with the following instructions when connecting the

various electrical devices.

2.2.2 Digital Video Connection

The 1700 unit provides 75 Ohm BNC connectors for digital video

input and output ports. Use the following procedure for

connections.

1. On the near end, connect the user’s digital video sources to

the 1700-T (transmitter) unit’s digital video input ports, using

a coaxial cable (i.e., Belden 8281 or better).

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Pas de commentaire

Broadata-communications 1700 Series Manuel d'utilisateur Page 7