Broadata-communications 285E Series Manuel d'utilisateur télécharger pdf (Page 6)

BCI 285E User’s Manual

Digital Fiber Optic Audio/Data Transport System

Broadata Technical Support, [email protected]

2.0 SETUP

The BCI 285E Series units are used in pairs. Equal transceivers are

located at both near-end and far-end locations and connected through

two optical fibers. Connections are one to one between both units. For

WDM applications, the 285E units are configurable for one fiber

connectivity. Figure 2-1 illustrates typical installations for the 285E.

Figure 2-2

285E Setup

2.1 Mounting

Before installing the units into your housing, make sure there is

enough space to pull and connect both the electrical and optical

cables without stressing them beyond the manufacturer’s

limitations (also known as the minimum bend radius).

2.2 Cabling and Connectors

In order to setup the BCI 285E properly, make sure to observe

the following instructions when installing the proper cables. The

285E requires two parts to the cabling setup: the electrical and

the optical.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Pas de commentaire

Broadata-communications 285E Series Manuel d'utilisateur Page 6